Venus blinds assembly instruction

After unpacking, please dismantle the blind and make sure that the distance washers are installed (plastic parts on the backside on both sides of the blinds), if not - please put it on.

1. Put the blind levelly to the upper window board and screw it to the window slash with a screwdriver or a drill driver.

   

2. Then, please thread levelly the line, which is on the both blind sides and mark points on the lower window board, where it will be installed. Countersink holes in the marked points with a drill driver ( ? 2mm bit ) and press the bolts, which are on the line ends, in it

   

3. Open the upper blind cover and tighten the line, as it will be very tight so that will make the rolling impossible after opening the window. On the end of the line, please tie up a small knot and cut the rest of the line, after that – close the side covers.

   

4. Tighten the coral chain and screw the holder at 10cm from the chain bottom to the binding. Then, install the holder outer part on the under-part and press it with force. After slamming, you can install the chain in the holder.